Safety edges are installed on the edges of various automatic doors and moving devices, as well as other locations where impacts and crushing may occur, to protect personal safety and equipment. The complete assembly consists of an aluminum rail, safety contact strip, and safety edge.

The special profile (rubber profile) of the safety edge protects the safety contact strip from damage and allows bending exceeding90 degrees.

Edges can be connected in series and monitored by a controller. The last safety edge requires a resistor. This design monitors the entire circuit for short circuits and breaks.

SGE Series

Safety Edge

Profile material isEPDM orTPE

Integrated safety contact and profile

End cap and cable connector included

Available in four sizes, maximum length6100mm

MaterialTPE

Material hardness68 Shore A

Maximum delivery length25 m

WeightKilogram/meter0.34

Protection classIP 65(IP 68 upon request)

Input impedance≤ 500 Ohm

Electrical load capacity24 V 10 mA

Operating temperature-10 °C ~ 50 °C

Maximum temperature range-25 °C ~ 75 °C

Maximum connection length for multiple edges100 m

Maximum number of safety edges in series5 safety edges

End zone30 mm

Cable materialPUR matte black

Customizable

Contact: Manager HouContact number: 13661967205