Product Introduction:

Cast aluminum solar road studs, also known as raised pavement markers, are protruding markers fixed on the road surface to serve as road markings. They can be used on highways or other roads to mark centerlines, lane dividers, and edge lines; they can also mark dangerous sections such as curves, entrance/exit ramps, diversion markings, road narrowings, and road obstacles. Since cast aluminum solar road studs operate in synchronous flashing mode, they are commonly used for road edges, green belt outlines, lane width indications, etc. They are highly effective facilities for urban beautification, fog guidance, and enhanced road marking recognition. Powered by solar energy and utilizing a wireless traffic controller, the light-emitting beads used are referred to as active light-emitting studs.

Product Name: Cast Aluminum Solar Road Stud

Model: XH-TBDD-101A

Specifications: 115*100*22mm

I. Technical Parameters:

1. Energy Storage Component: NI-MH high-temperature resistant battery 1.2V-800MAH, charge-discharge cycles >1000 times, capacity not easily reduced;

2. Solar Charging Battery: Monocrystalline silicon 5V 30MA;

3. Working Time: Under standard light intensity, 8 hours of exposure enables continuous operation for over 40 hours;

4. Operating Mode: Flashing (1Hz or 0.5Hz), single-sided or double-sided;

5. Display Device: Ultra-bright LED, luminous intensity >3000mcd (yellow, red) >5000mcd (white);

6. Light Colors: Red, yellow, white, blue, green, etc.; nighttime visible distance: 300 to 500 meters;

7. Product Material: Cast aluminum shell + epoxy resin filling;

8. Activation Light Intensity: Front illumination less than 500Lux;

9. Operating Environment: -20℃ to 70℃;

10. Installation: Epoxy resin adhesive bonding, can also be nailed for reinforcement, firm and stable, not easily detached;

II. Functions and Roles:

1. Light-emitting studs mainly refer to active light-emitting solar road studs. Solar road studs use solar energy to power LEDs, emitting various types of light to prompt and guide vehicles safely. They are primarily installed on special road sections such as curves and foggy areas, flashing at a certain frequency to attract the attention of drivers and passengers.

2. Combination studs integrate reflective and active light-emitting features, representing a new type of cast aluminum road stud product developed in recent years.

3. Cast aluminum solar road studs protrude from the road surface, creating vibration when vehicles pass over them, providing appropriate alerts to drivers and passengers. They are widely used on lane edge lines, lane boundaries where frequent lane changes are not allowed, road entrances/exits, and roads where vehicles need to slow down.